current position: Home > News > Corporate News
Sublimation ceramic knowledge class | What problems should we pay attention to in tile acceptance?
time: hit count:914Times
When decorating, ceramic tile is an inevitable building material. However, many owners feedback that they don't know how to check the paving quality of ceramic tiles. Don't worry, the sublimation ceramics knowledge class starts today. Learn about the four-step simple acceptance method with Xiaobian.
01, ceramic tile empty drum check
Inspection scope: window side and bathroom wall
Inspection method: Tap the corners and middle of the tile lightly with a small hammer or iron bar, and check whether the tile has empty drums. If the tile is empty, the sound will be different from other tiles.
If the sound is crisp, it is normal; If the sound is empty, it will be empty, and the decoration quality will be unqualified, which will easily fall off in the future.
02, tile drainage slope detection
Inspection scope: balcony, bathroom and kitchen, and check whether the floor drain is at the lowest place
Test method: throw a ball on the ground to see if it will automatically roll down the floor drain.
If the ball doesn't roll down the floor drain, it proves that the floor tiles are laid unevenly or the slope of dewatering is not enough. If you don't pay attention to this problem, it will bring a lot of trouble when you use it later.
03, tile shop is stuck to leave seam
Inspection scope: ceramic tile gap
In general, it is recommended to leave seams when paving ceramic tiles, which will expand with heat and shrink with cold. Even in seamless brick, the seam should be 1-1.5mm, but not less than 1mm. And ordinary ceramic tile, roughly between 3-5mm. Inspection method: Put the toothpick at the brick joint. If it can be put down just right, it will prove that there is no problem with the gap width of the ceramic tile.
04, wall brick floor tile
Inspection scope: junction of wall and ground
Inspection method: It can be seen whether the junction between wall and ground is a wall tile or not.
At present, most of our construction is pressure wall. However, in the process of pressure wall, there is a joint between wall tiles and floor tiles, which means that if water drips down from the wall, it will eventually flow along the joint to your waterproof layer, and it will accumulate there if it cannot seep down.
The wall-pressed tile paving method will make the whole space look more atmospheric and beautiful. There is no big gap around the ground, and the waterproof effect is good. However, the difficulty will be more complicated than the ordinary paving process, which will be more labor-consuming, and the requirements for the paving master will be higher.
Ceramic tile is one of the main building materials in home decoration. Ceramic tile should be checked and accepted before and after paving. It is better to master some common knowledge of ceramic tile checking and acceptance to ensure the quality and paving process of ceramic tile. These are the four tips of ceramic tile acceptance in today's sublimation knowledge hall, hoping to help your acceptance work.